8
Assembly Instructions: Prepare Workspace
Support Bracket (x2)
Control Box (pre-installed) Controller
Support Beam Legs (x2) (pre-installed) Feet (x2)
Lay down a blanket and place your Seville Classics
®
Ergo Table Top (or your
own top) with the bottom side facing up on a soft, at, even surface
beneath the top to protect the surface.
Layout all components and hardware. Examine each and make sure
components are without damage.
Examine the location where you'll be
using the desk. Make sure there is a
grounded outlet or power strip nearby.
Assemble frame with CONTROL BOX (F)
on the side of the nearest outlet.
110-120V
To Next Page
Loading...
