SEW-Eurodrive MOVIMOT flexible MMF3 C/DBC Series - Resetting Fault Messages; Description of Status and Operating Displays

8
Service
Resetting fault messages
Operating Instructions – MOVIMOT
®
flexible
195
8.4 Resetting fault messages
WARNING
Removing the source of the malfunction or performing a reset can result in an auto-
matic restart of the connected drives.
Severe or fatal injuries.
• Prevent unintended startup.
Acknowledge fault message by:
• Switch the supply system off and on again.
• Via the controller/PLC: Send "reset command".
8.5 Description of status and operating displays
8.5.1 LED displays of the binary control
The following figure shows the LEDs of the binary design:
DBC10A-0020-503-A-000-000
Binary
DRIVE
[1]
18014427523368971
[1] "DRIVE" status LED
29129451/EN – 12/2019