SEW-Eurodrive MOVITRAC LTE-B+

Other manuals for SEW-Eurodrive MOVITRAC LTE-B+

Manual48 pages

Questions and Answers

P
Philip RussellAug 3, 2025
What to do if SEW-Eurodrive DC Drives display shows "StoP"?
- K
  karen66Aug 3, 2025
  If the display shows "StoP" and the inverter doesn't enable, first check if the hardware enable signal is present at digital input 1. Then, ensure a proper +10 V user output voltage is present between terminals 5 and 7. If there's still a problem, check the wiring of the user terminal strip. Also, check parameter P-12 to see if it's in terminal mode or keypad mode. If it's in keypad mode, press the "Start" key. Finally, verify that the line voltage corresponds to the specified values.
J
Jacob JeffersonAug 9, 2025
How to access advanced menus on SEW-Eurodrive DC Drives?
- G
  Gina GreenAug 9, 2025
  If you can't access advanced menus on your SEW-Eurodrive DC Drives, parameter P-14 must be set to the advanced access code. The default value is "101", but check P-37 in case the user has changed the code.
J
Jesus RobertsAug 15, 2025
Why SEW-Eurodrive MOVITRAC LTE-B+ DC Drives inverter does not start in cold conditions?
- J
  Jonathon WilliamsAug 15, 2025
  If your SEW-Eurodrive DC Drives inverter doesn't start in extremely cold conditions (below –10 °C), use a heat source to maintain the ambient temperature of the drive above -10 °C.
D
David MendozaAug 21, 2025
What to do if SEW-Eurodrive MOVITRAC LTE-B+ motor does not turn due to overload?
- R
  robertedwardsAug 21, 2025
  If the SEW-Eurodrive DC Drives motor doesn't turn and there's an overload or overcurrent, check if the rotor is blocked. Also, ensure that the mechanical brake is released, if one is installed.
S
Sharon VasquezAug 27, 2025
How to fix overload error during acceleration in SEW-Eurodrive MOVITRAC LTE-B+?
- B
  Brian ThomasAug 27, 2025
  If you are experiencing an overload or overcurrent error with an unloaded motor during acceleration with SEW-Eurodrive DC Drives, check the star/delta terminal connection in the motor. Ensure that the nominal operating voltage of the motor and inverter match. Remember that the delta connection always yields the lower voltage of a multi-voltage motor.