SEW-Eurodrive MOVIMOT flexible MMF3 C/DBC Series - Page 244

8
Service
Fault/error table
Operating Instructions – MOVIMOT
®
flexible
244
Subfault: 33.2
Description: Firmware CRC check
Response: Output stage inhibit
System state: Fault acknowledgment with CPU reset
Cause Measure
Error checking firmware. Contact the SEW‑EURODRIVE Service.
Subfault: 33.6
Description: FPGA configuration
Response: Output stage inhibit
Cause Measure
Error checking FPGA configuration. Contact the SEW‑EURODRIVE Service.
Subfault: 33.7
Description: Function block compatibility error
Response: Output stage inhibit
Cause Measure
Error checking compatibility of function block. Contact the SEW‑EURODRIVE Service.
Subfault: 33.8
Description: SW function block configuration
Response: Output stage inhibit
Cause Measure
Error detected while checking configuration of
software function block.
Contact the SEW‑EURODRIVE Service.
Subfault: 33.9
Description: Power section hardware compatibility fault
Response: Output stage inhibit
Cause Measure
Firmware does not match hardware of power sec-
tion.
Contact the SEW‑EURODRIVE Service.
Subfault: 33.10
Description: Run-up timeout
Response: Output stage inhibit
System state: Fault acknowledgment with CPU reset
Cause Measure
Timeout during system run-up. Contact the SEW‑EURODRIVE Service.
29129451/EN – 12/2019