Sewha SI 4010 - Page 26

DIGITAL WEIGHING INDICATOR
SI 4010
26
■ Communication Mode setting (Serial Port 2. - Optional Serial port)
Parity Bit selection Mode
F60
●
0
DATA Bit (8 Bit)
STOP Bit (1 Bit)
Parity Bit (Non)
1
DATA Bit (7 Bit)
STOP Bit (2 Bit)
Parity Bit (Non)
2
DATA Bit (7 Bit)
STOP Bit (1 Bit)
Parity Bit (Even)
3
DATA Bit (7 Bit)
STOP Bit (1 Bit)
Parity Bit (Odd)
4
DATA Bit (8 Bit)
STOP Bit (2 Bit)
Parity Bit (Non)
5
DATA Bit (8 Bit)
STOP Bit (1 Bit)
Parity Bit (Even)
6
DATA Bit (8 Bit)
STOP Bit (1 Bit)
Parity Bit (Odd)
Serial Communication Speed selection
F61
0
2,400bps
1
4,800bps
●
2
9,600bps
3
14,400bps
4
19,200bps
5
28,800bps
6
38,400bps
7
57,600bps
8
76,800bps
9
115,200bps
DATA Transference Method selection
F62
●
0
Simplex Mode / Stream Mode
1
Duplex Mode / Command Mode
“Check-Sum” detection selection (Under F62-01 setting, only)
F64
●
0
Check-Sum data will not be included on transferred data.
1
Check-Sum data will be included on transferred data.
DATA Transference Mode selection (Under F62-00, F65-00 setting, only)
F66
●
0
Stream Mode : Weighing Data will be transferred continuously.
1
Steady Mode : When the Weight is steady over than EMPTY
2
Manual Mode : When “Print” key input, 1 time transferred.
DATA Transference Format selection(Under F62-00, F65-00 setting, only)
F67
●
0
Format 1.
1
Format 2. (Format 1 + ID No.)
2
CAS Format