Sewha SI 550 - 5-3-2. Hidden Function Setting Mode

- 30 -
SI 510 WEIGHING INDICATOR
5-3-2. Hidden Function Setting Mode
This setting become enter the hidden Function..
How to enter Hidden Function Setting Mode : Press "F2" key 4 times and input your
password. (1111)
* Key function: F1 – Move hidden function number / Enter – Save
Serial Number Check
HF01
Check your device's serial number.
S/W Version Check
HF02
Check the currently applied program version.
H/W Version Check
HF03
Check the currently applied hardware version.
DATE(Y,M,D) Check / Modification
HF04
Check the date or adjust when it is wrong.
TIME(H,M,S) Check / Modification (24Hours)
HF05
Check the time or adjust when it is wrong.
Password Setting (4digit)
HF06
Password is required when you enter to hidden function.
Enter the password twice.
Password combination within 0~9.
Maximum Capacity Weight Check
HF07
Check the max capacity which is set under calibration mode.
Span Value Check / Modification
HF08
Check the Span Value.
Analog Output Setting Set up
HF09
●
00
4-20mA Output use
01
0-10V Output use
Min Analog Output Setting
HF10
Minimum Analog Output (Analog out 4~20mA / 0~10V).
The 4-20mA’s begin number is “0”, so after enter the Function mode and write the “4” to
show “4mA” key press (–) Setting. Input range : -20 ~ +20 , basic value : 0
Max Analog Output Setting
HF11
Maximum Analog Output (Analog out 4~20mA / 0~10V).
The 4-20mA’s begin number is “0”, so after enter the Function mode and write the “-4” to
show “20mA”
key press (–) Setting. Input range : -20 ~ +20 , basic value : 0
Function List Reset
HF14
Change the function list reset.
Factory Reset
HF15
Change the all function to the factory reset.
Ip Address Check / Modification
HF16
Check the Ip Address.