Need help?Do you have a question about the Sewha SI 480E and is the answer not in the manual?
Explains warning and caution symbols used in the manual.
Outlines manual rights and provides contact details for inquiries.
Welcomes the user and introduces the SI480E Weighing Indicator.
Lists essential safety rules and warnings for operating the indicator.
Highlights the main features and advantages of the SI480E indicator.
Provides a comprehensive list of the indicator's technical specifications.
Describes the visual components and interactive keys on the front panel.
Explains the meaning of each status lamp on the indicator's front panel.
Details the specific actions performed by each key in various operating modes.
Explains special functions accessed via the 'F' key in combination with others.
Details the connectors and terminals located on the rear of the indicator.
Provides physical dimensions and required panel cut-out for installation.
Lists and identifies the hardware components provided for installation.
Explains how to correctly wire and physically mount the load cell.
Step-by-step guide to access the indicator's setup menu.
Instructions for using and managing the setup mode password.
Provides an overview of the weight calibration process.
Provides an overview of the simulation calibration process.
Explains how to access and navigate the F-FUNCTION settings.
Introduces the functions available within Test Mode 1.
Explains the role of each key during the calibration process.
Procedure to start the test weight calibration sequence.
How to input and set the maximum capacity of the weighing scale.
Guide to configuring the decimal point and digit division for display.
Process for automatically measuring the dead weight of the weighing scale.
Steps to input test weight and compute the span value.
Procedure to initiate the simulation calibration process.
Inputting the maximum capacity of the connected load cell.
Configuring the digit and division settings for the display.
Measuring the dead weight of the scale during simulation calibration.
Entering the load cell's rated output voltage (mV).
Guide to setting and optimizing F-FUNCTION parameters.
Comprehensive list and explanation of all F-FUNCTION settings.
Configuration of Empty Range and procedures for communication testing.
Instructions for managing date, time, and setup mode password.
How to check the indicator's software and hardware versions.
Details on the diagnostic tests available in Test Mode 1.
How to check live analog values displayed on the indicator.
Procedure to monitor and check variations in analog values.
Testing the functionality of the front panel keys and digital inputs.
How to perform a diagnostic test of the serial communication interface.
Details on connecting the indicator via RS-485 serial interface.
Details on connecting the indicator via RS-422 serial interface.
Instructions for RS-232 connection and sensitivity to noise.
Explains the structure and content of different serial data formats.
Details the CAS (22-byte) data format for communication.
How the indicator responds to commands in command mode.
Format for reading the current weight data.
Format for reading stored indicator memory data.
Format for reading accumulated grand total data.
Format for retrieving the finished weight data.
Formats for reading current time and date information.
Format for retrieving tare value data.
Commands for zero, tare, hold, and print functions.
Command for setting the current date on the indicator.
Formats for setting the indicator's time and serial number.
Practical examples of using read commands with PC communication.
Practical examples of using write commands with PC communication.
Explains different print formats like continuous, single, and grand total.
Troubleshooting guide for errors caused by load cell installation issues.
Addresses errors related to unstable or incorrect weight readings.
Explains and provides solutions for display errors like UN PASS and OL/UL.
Lists calibration error codes and their specific troubleshooting steps.
Solutions for common indicator display errors like CELL-Er, OVER, UNPASS, etc.
Details warranty coverage, exceptions, and contact information.
General| Brand | Sewha |
|---|---|
| Model | SI 480E |
| Category | Accessories |
| Language | English |
To Next Page
