24
SFE
4.4.2 Regeneration
When the module is in regeneration, the display shows the following information:
• During the transition phases nC-|, where n is the number of the regeneration cycle
phase, a turning bar is display to mean that a transition is occurring from a regeneration
phase to the next one.
• During the stopping phases nCxx|, where n is the number of the regeneration cycle
phase and xx are the residual minutes before switching to the next phase.
• Regeneration in progress icon, steady on.
4.4.3 Battery operation
When the module is battery supplied, the display shows the following information:
• Time: xx:xx with flashing “:”.
• Weekday, if the day of the week is flashing it means that the regeneration is enabled for
that day.
• Service icon
• Residual volume and time are displayed alternately, if volume regeneration is enabled.
• The battery icon is displayed
Phase in progress and time remaining before passing to the next step
Transition to phase 1
E
N
G
L
I
S
H
To Next Page
Loading...
