The treated volume is displayed on a running string so as to allow reading a number
greater than 9999.
Press to switch parameters.
The date and time information for the last regenerations carried out are only available if
regenerations have been carried out.
While the statistics are displayed, the regeneration icon is on, if not otherwise indicated.
4.8 Statistics reset
To reset the statistics, move to the first parameter (number of regenerations carried out),
press and hold for 5 seconds; the statistical data are reset and the display shows a
flashing CLS for few seconds.
4.9 Reset eeprom
To reset the eeprom to the default values, proceed as follows. In the service condition
(regeneration cycle not running and clock displayed):
- To open the Statistics menu, press and hold for 5 seconds.
- Press and release the
- Press and release the
- Press and release the
- Press and hold the for about 5 seconds
The display shows “rSt” for a few seconds; this means that the eeprom has been reset to
the default values.
NOTE: this procedure does not reset statistical data.
26
SFE
E
N
G
L
I
S
H
To Next Page
Loading...
