18
The following error messages may be displayed during operation:
Salt alarm, the brine tank is empty. Press any key to acknowledge this alarm
and reset the salt alarm counter to the programmed value. No regenerations are
carried out during the salt alarm.
Microswitch alarm. The module cannot find the service position. No regenerations are
carried out during the microswitch alarm.
The SFE controller is fitted with a hardware reset button located on the board itself close to the display
and not directly reachable by the user.
Button to reset the SFE board
After a hardware reset, the time on the display flashes until any button is pressed.
Hardware reset button
ERROR MESSAGES
RESET HARDWARE
To Next Page
Loading...