PILOT 2000 USER GUIDE
Programming
To program a Preset:
1. Select a Memory
2. Press Preset button;
3. Press a button 1-20 (21-40) of the MFK according to the preset to be created
4. Press Edit key (red LED on the Edit button and the green LED of the MFK preset will
blink)
5. Rise the fader below the display to set the desired value to the dimming channels. In
case of more than 6 channels, use the scroll button (located on the right of the display)
to set other channels.
6. Press Edit key
7. Press Enter key
8. Your Preset is now stored
To program a Psycho:
1.Select a Memory
2.Press Psycho button
3.Press a button 1-20 (21-40) of the MFK according to the psycho to be created
4.Press Edit key (red LED on the Edit button and the green LED of the MFK psycho will
blink)
5.Select the sound frequency band where you want your dimming channels to work.
The first 4 buttons (from left to right) identify the four bands
6.Rise the fader below the display to set the desired value for each dimming channel
7.Press Edit key
8.Press Enter key
9.Your Psycho is now stored
To edit a Chase:
1. Select a Memory
2. Press Chase key
3. Press a button 1-20 (21-40) of the MFK according to the program to be created
4. Press Edit Key
5. Press right arrow of the scroll buttons (located on the right of the display)
6. Select Edit Step from the edit menu
7. Press right arrow of the scroll buttons
8. Rise the fader below the display to set the desired value for each channel
9. Press and hold down the Store key
10.At the same time push the MFK button corresponding to the step to be stored
11.Repeat from the above item 7 till the last step is programmed
12.Push the left arrow until the display shows the program number and the Length of the
steps
13.Press Edit button
14.Press Enter button
15.Now your Chase is stored
14
SGM A/S · Ver. 2.03
To Next Page
Loading...
