PILOT 2000 USER GUIDE
To select a Chase:
1. Press Chase key
2.Press a button of the MFK according to the chase to be created or modified
Up to 4 Chases at the same time can be run in one memory.
To select a Psycho:
1. Press Psycho key
2.Press a button of the MFK according to the psycho to be created or modified
Up to 4 Psychos at the same time can be run in one memory.
To select a Preset:
1. Press Preset key
2.Press a button of the MFK according to the preset to be created or modified
Up to 4 Presets at the same time can be run in one memory.
To allocate a Memory Obj to a Memory:
1. Select a Memory
2. Select the Memory Obj to be assigned to a Memory
3. Press and hold down the Store button
4. Press a button of the MFK according to the Memory to be stored
5. Release Store button. The memory is now stored.
To copy the contents of a Memory to another:
1. Select the source Memory
2. Press and hold down the Store button
3. At the same time press a button of the MFK according to the target Memory to be
copied
4. Release Store button. The target memory is now copied.
To select a Unit:
1. Press Unit key
2.Press a button of the MFK according to the unit to be used manually or plotted in a
program.
Group of units:
There are 6 groups of units available which can be stored and recalled by using the 6 light
gray buttons located below the faders of the scan control section.
SGM A/S · Ver. 2.03
9
To Next Page
Loading...
