sharkclean.eusharkclean.eu
MAINTENANCE
To reinstall, place bottom of dust cup into pod and
then tilt it until it clicks into place.
Press the button on the bottom of the dust cup to
release debris into the trash.
To remove the dust cup from the Lift-Away® pod, slide
up both Dust Cup Release latches on the back of the
handle at the same time and pull out the dust cup.
To remove collected debris from Mesh Screen,
press top release button and lift handle to open.
IMPORTANT: Unplug the power cord before performing any maintenance.
EMPTYING THE DUST CUP
CLEAN HEPA FILTER
EVERY YEAR
Press the Cover Latch above the Filter Cover,
then pull off the cover. Push the tab on the
front of the cover to detach the HEPA Filter.
To replace the HEPA filter, snap it back into
the pod, then slide-on the cover until it clicks
into place.
CLEAN PRE-MOTOR FILTERS
ONCE A MONTH
Remove Dust Cup, then lift out the Filter
Frame. Pull up the Foam Filter to remove it
from the filter frame. The Felt Filter is built
into the support frame.
To reinstall, insert the bottom of the dust cup
into the pod and tilt it until it clicks into place.
Regularly clean and replace the filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water only. Allow all filters to air-dry for at least 24 hours before
reinstalling them to prevent liquid from being drawn into electric parts.
MAINTENANCE
CLEANING FILTERS
IMPORTANT: DO NOT use soap when cleaning the filters.
Foam Filter
Filter Frame
Cover Latch
HEPA Filter
Filter Cover
NOTE: To order replacement parts and filters, visit sharkaccessories.com.
Replacement
Pre-Motor Foam &
Filter Support Kit
Replacement
HEPA Filter
The Pre-Motor Filters should be replaced every 2.5 years. The HEPA Filter should be replaced every 3 years.
REPLACING FILTERS
PRE-MOTOR FILTERS HEPA FILTER
To Next Page
Loading...
Need help?
General
