sharkclean.eusharkclean.eu
MAINTENANCE
FLOORHEAD MAINTENANCE
CLEANING THE SOFT ROLLER
NOTE: For best performance, keep the Soft Roller clean with regular maintenance.
1 To remove the Soft Roller, slide the Eject Roller
button on the floor nozzle.
2 Tap loose debris off the Soft Roller. Use a dry
towel to wipe it clean, and to remove any debris
caught in the teeth behind the Soft Roller.
3
Hand-wash the Soft Roller as needed. Use only
water, and let it air-dry completely for at least
24 hours.
4
Reinsert the Soft Roller and press it in until it clicks
securely into place.
If you notice any hair wrap, continue
vacuuming and the Brushroll will
automatically remove it.
To remove the cover, use a coin to turn the
locks counterclockwise. Lift off the cover
and remove any debris or hair wrap. Check
the Debris Intake and clear away any dirt or
blockages.
To close the cover, push down until it clicks
into place, then turn the locks clockwise
until closed.
CHECKING FOR BLOCKAGES
MAINTENANCE
Remove the dust cup from the pod to check the
intake opening inside. Then detach the pod from the
wand to check the hose.
Detach the wand, then remove the Soft Roller.
Tilt the floor nozzle tube back and check openings
for blockages. Reinsert Soft Roller until it clicks
securely into place.
Remove any blockages or debris from the floor
nozzle debris intake (See Nozzle Maintenance
section).
What does the Brushroll Indicator Light mean?
Solid Green: The brushrolls are spinning and
working properly.
Solid Red: There is a jam in the brushroll area. Turn
your vacuum off and remove any blockages in the
nozzle.
Flashing Red: The motorized floor nozzle is
overheating. Turn your vacuum off, unplug from
the wall, and wait a minimum of 45 minutes for it to
cool down.
Detach the wand and check it for blockages.
CHECK POD
CHECK FLOOR NOZZLE BRUSHROLL INDICATOR LIGHT
CHECK WAND
To Next Page
Loading...
