1.
Turn off the vacuum.
2. Using a coin, turn locks counterclockwise to open, then lift off cover to access brush-roll.
3. Clear airway of blockages.
4. Replace cover by sliding inserts into slots, then pressing down firmly on all sides before turning
locks clockwise to close. There will be an audible click once the locks are secured.
NOTE: Anti Hair Wrap Technology removes hair from your brush-roll continuously as you vacuum. At
times you may see
small amounts of hair around the brush-roll – simply continue vacuuming and the comb and suction
will remove
the hair as you clean.
To Next Page
Loading...
