CLEANING SENSORS AND CHARGING PADS
CLEANING SIDE BRUSH
MAINTENANCE
Carefully unwind and remove any string or hair
wrapped around brush.
Gently wipe brush with a dry cloth. To reinstall, snap
the brush over the peg. Spin the brush manually to
make sure it is installed correctly.
CLEAN SENSORS AND CHARGING PADS AS NEEDED. With a dry cloth, gently dust o the sensors and
pads located on the bottom of the robot and on the base.
NOTE: Remove and replace any side brush that is bent or damaged. To remove a brush, lift it o its peg.
IMPORTANT: The robot uses cli sensors to avoid stairs and other steep drops. Sensors may work less eectively when
they are dirty. For best results, clean sensors regularly.
CLEAN SIDE BRUSH AS NEEDED.
To Next Page
Loading...
