12
TOLL FREE: 1-800-798-7398
Maintenance
Resetting the Motor Thermostat
Your Shark
®
Upright Vacuum is
equipped with a protective Motor
Thermostat. If the motor should
overheat, the thermostat shuts off
the power.
To reset the Motor Thermostat:
Move the Power Button to the
“
O
– Off” position.
Unplug the vacuum.
Check for clogged hose or filter;
unclog hose and replace filter.
Refer to Checking for Blockages
on page 11.
Wait 45 minutes for vacuum to cool;
then plug in the vacuum.
Turn the Power Switch to the
“I – On” position to start the
vacuum.
Note: if vacuum still does not start,
contact Customer Service at:
1-800-798-7398.
1 Cleaning the Pet Hair Power
Brush -
Slide locking latch (A) forward.
Gently tilt brush housing upward
to open.
IMPORTANT: DO NOT force; it
will not open all the way.
Remove debris from turbine
wheel and air passage.
A
Ordering Replacement Parts
To order additional parts and
accessories, go to
www.sharkclean.com
or call 1-800-798-7398.
PART PART NO.
Super Stretch Hose 1114-FC
Dusting Brush &
Crevice Tool 1115-FC
Foam & Felt Filters XF22
Turbo brush 1117-FC
Cleaning Wand 1116-FC
24"Crevice Tool 1124-FC
UV400_26_IB_ENG_SPA_110111.indd 12 11-01-11 1:45 PM
To Next Page
Loading...
