ASSEMBLING THE VERTICAL PRESS PAD
1 Insert the garment hook into the top of the
vertical press pad (Fig. 1). Insert one of the
support rods into the opening on the side of
the Vertical Press Pad making sure that it is
inserted firmly into the hook (Fig. 2). Do the
same with the other support rod from the
other side.
2 The Vertical Press Pad comes assembled with
heat protection panels in the pockets on the
back. These panels protect your door from
heat damage and should be in place at all
times during use.
3 Slip the webbing bands at the top of the
vertical press pad over either side of any door
with the terry cloth side facing away from
the door. With the door open, loop the band
around the corner of the door and repeat
on the opposite side. Gently tug on the pad
to make sure it is secure and shut the door
completely to ensure the Vertical Press Pad is
stable for pressing. Be careful not to close the
door on your fingers. Adjust the straps on the
webbing to the appropriate height for comfort
(Fig. 3).
4 The heat protection panels should be
removed before washing the vertical press
pad. To remove the panels for washing, undo
the Velcro
™
tabs and slide the panels out.
5 Machine wash the press pad in cold water on
the gentle cycle and lay flat to dry.
Fig. 3Fig. 2
Fig. 1
Assembly of the Vertical Press Pad
TOLL FREE: 1-800-798-7398 ww w.sha rkclean.com
GS500C_100611
GS500 E/F Press Pad sheet.indd 1 10-06-11 4:57 PM
To Next Page
Need help?
General
