Why is there no steam coming from my Shark Steam Cleaner?
First, make sure your Shark Steam Cleaner is turned on by checking if the blue light is lit. If it's not, ensure the unit is plugged in and the on/off button is in the 'I' position. Also, verify that the water tank is at least half full, or fill it to the maximum fill line.
What to do if my Shark Press & Refresh GS500UKL leaves water drops on clothes?
If your Shark Steam Cleaner nozzle leaves water drops on the garment, make sure the small steam bonnet frame is always in place during use. If the steam bonnet is too wet, let the unit cool for 30 minutes, then remove the steam bonnet and let it dry before using it again, or replace it with a new one. Also, if the frame has condensation, let the appliance cool and wipe the frame off.
Instructions for attaching the small steam bonnet frame to the garment steamer unit.
Guidance on using the vertical press pad and VELCRO clips for steaming garments.
Step-by-step guide for assembling the vertical press pad onto a door.
Instructions for unpacking and checking components before assembling the garment steamer.
Instructions for cleaning the heat protection panels and garment hook of the vertical press pad.
Procedure for safely filling the water tank using the provided filling flask.
Steps for attaching different frames and bonnets to the garment steamer unit.
How to use the garment steamer with the vertical press pad for steaming.
Guide for using the garment steamer horizontally for upholstery and home fabrics.
Procedure for cleaning and storing the garment steamer and its components.
General| Product Name | Shark Press & Refresh GS500UKL |
|---|---|
| Category | Steam Cleaner |
| Power | 1600 W |
| Heat-up Time | 30 seconds |
| Steam Output | 25 g/min |
| Accessories | Microfibre pads, Crevice tool |
To Next Page