WHAT’S INSIDE: ASSEM B LY
For complete maintenance instructions, see the enclosed Owner's Guide.
For additional parts and accessories, visit sharkaccessories.com.
For additional batteries and charging accessories, visit sharkclean.com/batteries.
F G
A
Handheld Vacuum
B
Dirt Engage™ Floor Nozzle
C
Wand
D
Pet Multi-Tool
E
8" Crevice Tool
F
Charger
G
Post Motor Filter (Pre-Installed)
ED
POWER SETTINGS
LI-ION BATTERY
NOTE: The Li-Ion battery
comes partially charged.
Charge fully before first use.
Battery Indicator Lights
A
B
C
2
(Click)
1
(Click)
OFF
BARE FLOOR
SETTING
CARPET SETTING BOOST MODE
Slide switch to the
top to turn o power.
To begin vacuuming
in Standard Mode,
slide switch to the
appropriate setting.
Bare Floor/Area Rugs
The brushroll spins slowly
to clean bare floors and
low-pile arearugs.
The brushroll spins
faster to pick up debris
below the surface
ofyour carpets.
For an added boost in
power, pull the Trigger
on the handheld
vacuum. Release it
to return to standard
power.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select the Carpet setting and pull the
trigger to go into Boost mode.
NOTE: Select Carpet setting for stuck-on dirt and debris.
In Use
Full
Charge
Mid
Charge
Low
Charge
Nearly
Empty
No
Charge
Charging
Low
Charge
Mid
Charge
Nearly
Full
Full
Charge
NOTE: Full charge takes approximately 3 hours.
CHARGING
To charge, remove the handheld vacuum from the wand by
pressing the Wand Release button and pulling up. Plug the
charger into the charging port.
©2019 SharkNinja Operating LLC.
Battery Run Time
MODE MINUTES
Hand Vac 40
Bare Floor/
Standard Mode
25
Carpet Mode 22
Boost Mode
(Hand Vac)
10
To Previous Page
Loading...
Need help?
General
