Shark ROCKET IZ142 User Manual

QUICK
START
GUIDE
Please make sure to read the enclosed Shark® Owner’s Guide prior to using your vacuum.
IZ142_QSG_MP_Mv7
EMPTYING THE DUST CUP
IZ142
Use this Quick Start Guide
to start using your new
vacuum’s great features.
For questions, visit us online
at sharkclean.com/support
Register your vacuum at
registeryourshark.com
CORDLESS MULTIFLEX®
ROCKET®
1. To empty the dust cup,
first disconnect the
handheld vacuum from
the wand by pressing
the Wand Release
button and pulling
up on the handheld
vacuum.
Wand Release
Button
CleanTouch
Dirt Ejector
VERSATILE CLEANING
Slide the power button
to the desired power
setting. Place your foot
on the floor nozzle
and tilt the handheld
vacuum back.
To detach the wand for
above-floor cleaning, stand
the vacuum upright, then
press the Nozzle Release
button on the bottom of the
wand and pull the wand up
to disconnect it.
To detach the handheld
vacuum, press the Wand
Release button and lift the
handheld vacuum o the
wand.
Attach a cleaning accessory,
then choose the power
setting.
NOTE: Brushroll will only engage
when the handle is tilted back.
OR
THEN
2. Position the dust
cup over a trash
bin and slide the
CleanTouch™ Dirt
Ejector forward.
©2019 SharkNinja Operating LLC. SHARK and ROCKET are registered trademarks of SharkNinja
Operating LLC. CLEANTOUCH and DIRT ENGAGE are trademarks of SharkNinja Operating LLC.

Shark ROCKET IZ142 Specifications

General

Type	Cordless Stick Vacuum
Battery Life/Cord Length	40 minutes
Filtration	HEPA Filtration
Cord Type	Cordless
Attachments	Crevice Tool, Dusting Brush
Dust Cup Capacity	0.5 quarts
Features	LED Headlights

Summary

Versatile Cleaning

Detaching the Wand

To detach the wand for above-floor cleaning, stand the vacuum upright, then press the Nozzle Release button.

Detaching the Handheld Vacuum

To detach the handheld vacuum, press the Wand Release button and lift the handheld vacuum off the wand.

Emptying the Dust Cup

Step 1: Disconnect Handheld Vacuum

Disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up.

Step 2: Eject Dust

Position the dust cup over a trash bin and slide the CleanTouch™™ Dirt Ejector forward.

Power Settings

Off Mode

Slide switch to the top to turn off power.

Bare Floor/Area Rugs Mode

Brushroll spins slowly to clean bare floors and low-pile area rugs.

Carpet Mode

Brushroll spins faster to pick up debris below the surface of your carpets.

Boost Mode

Pull the Trigger for an added boost in power. Release it to return to standard power.

Li-Ion Battery Information

Battery Indicator Lights

Shows the Li-Ion battery charge level. Charge fully before first use.

Charging Process

Remove handheld vacuum, press Wand Release, pull up, and plug charger into port.

Battery Run Time Estimates

Shows estimated run time for different modes (Hand Vac, Bare Floor, Carpet, Boost).