Shark SSG-403037E User Manual

SSG 579-585 • 9.801-193.0 • Rev. 1/13a
9
PRESSURE WASHER
OPERATOR’S MANUAL
98011930-16
OPERATING INSTRUCTIONS
STEP 7: (Electric Start Models) Turn the engine
switch to "Start" position.
STEP 10: (Pump Steam Option)
A. Operate machine as instructed.
B. Open steam valve counter-
clockwise, which will lower
pressure.
C. Turn thermostat knob to 250°F.
D. When steam is no longer desired,
Turn steam valve clockwise and
thermostat knob to 200°F.
STEP 9: Turn the burner switch
“ON”. Turn thermostat dial to the
210° mark.
Thermostat
Burner
Switch
STEP 8: (Electric Start Models) Turn the key to the
START position, and hold it there until the engine starts.
If the engine fails to start within 5 seconds, release the
key, and wait at least 10 seconds before operating the
starter again.
Using the electric starter for more than 5 seconds
at a time will overheat the starter motor and can
damage it.
When the engine starts, release the key, allowing it to
return to the ON position. If the choke knob has been
pulled to the CLOSED position to start the engine,
gradually push it to the OPEN position as the engine
warms up.
98011930-18
Safety
Latch
98011930-15
ON
OFF
START
Engine
Switch
98011930-14
On-Off
Switch
WARNING! Never replace noz-
zle without engaging the safety
latch on the spray gun trigger.
98011930-17
Steam
Valve

Shark SSG-403037E Specifications

General

Brand	Shark
Model	SSG-403037E
Category	Pressure Washer
Language	English