SX-68JF200
19
NO. Check item Adjusting procedure and conditions Waveform and others
1 When OI-9CH PAL COLOUR BAR is received
and M, B/G, I is selected in the sound system,
Verify that the sound must not be properly
output.
2 When E-23CH monoscope is received and
M, B/G, D/K is selected in the sound system,
Verify that the sound must not be properly
output.
3 When E-12CH colour bar is received and M,
I, D/K is selected in the sound system,
Verify that the sound must not be properly
output.
4 When JA-8CH colour bar is received and B/
G, I, D/K is selected in the sound system,
Verify that the sound must not be properly
output.
Note: Take care that the colour and
sound must not be properly
operated with the special signal
E-4, E-37, J-38 and E-64 in the
auto mode.(Check it in the
forcible mode.)
SOUND SYS-
TEM
1 Receive E-5CH music broadcast.
2 The sound mode must be switched with
SPATIALIZER key (R/C) as follows.
SPATIALIZER OFF ↓
SPATIALIZER 1 ↓
SPATIALIZER 2 ↓
3 Verify that the sound from the speaker in the
MONO mode is felt to be wide.
R/C key or MENE screen
14
1 Receive E-5CH music broadcast.
2 Switch S-BOOSTER in S-mode as below.
OFF – 1 – 2 – 3
S-BOOSTER
FUNCTION OPERATION CHECK (2) (VIDEO AND AUDIO)
11 COLOUR
SYSTEM
1 When E-12CH PAL COLOUR BAR is received
and another mode except PAL is selected in
the colour system,
Verify that the colour must not be properly
operated.
2 When E-10CH SECAM COLOUR BAR is re-
ceived and another mode except SECAM is
selected in the colour system,
Verify that the colour must not be properly
operated.
3 When E-37CH NTSC 4.43 COLOUR BAR is
received and another mode except N4.43 is
selected in the colour system,
Verify that the colour must not be properly
operated.with UP/DOWN.
4 When JA-8CH NTSC 3.58 COLOUR BAR is
received and another mode except N3.58 is
selected in the colour system,
Verify that the colour must not be properly
operated.
12
13
SPATIALIZER
Key
To Next Page
Loading...
