EN-5EN-5
LOADING BATTERIES
1
Remove the battery cover.
2
Insert two batteries.
(AAA(R03))
Makesurethe(+)and(-)polaritiesare
correctly aligned.
3
Reinstall the battery cover.
4
Press the RESET button using a
thin stick.
NOTE:
•
Thebatterylifeisapproximately1yearin
normal use.
•
Replacethebatterieswhentheremotecontrol
displays “ ”.
• Whenreplacingthebatteries,alwayschange
bothandusethesametype.
• Ifyouwillnotbeusingtheunitforalongtime,
removethebatteriesfromtheremotecontrol.
USING THE REMOTE CONTROL
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the
receiver window and press the desired
button. The unit generates a beep when
it receives the signal.
•Makesurenothing,suchascurtains,blockthe
signalreceiverwindow.
•Thesignaleffectivedistanceis7m.
CAUTION:
•Donotexposethereceiverwindowtodirect
sunlight.Thismayadverselyaffectitsoperation.
•Useofcertainuorescentlampinthesame
roommayinterferewithtransmissionofthe
signal.
•Donotleavetheremotecontrolindirect
sunlight or near a heater. Protect the remote
control from moisture and shock.
Batterycover
RESETbutton
7 m
Receiver
window
Use this mode when the remote control
is not available.
TO TURN ON
Press the AUX button.
•ThegreenOPERATIONlamp( )willlightup
andtheunitwillstartoperatingintheAUTO
mode.
•Thefanspeedandtemperaturesettingareset
toAUTO.
TO TURN OFF
Press the AUX button again.
•ThegreenOPERATIONlamp( )willturnoff.
AUXILIARY MODE
TIPS ON SAVING ENERGY
Below are some simple ways to save
energy when you use your air conditioner.
Set the proper temperature
•Settingthetemperaturelowerthannecessary
duringcoolingoperationwillresultinincreased
powerconsumption.
Block direct sunlight and prevent drafts
•
Blockingdirectsunlightduringcoolingoperation
willreducepowerconsumption.
•Closethewindowsanddoorsduringcooling
and heating operations.
Keep lter clean to ensure the most
efcient operation
Disconnect the power cord when the
unit is not used for an extended period
time
•Theindoorunitstillconsumesasmallamount
ofpowerwhenitisnotoperating.
AUX