53
6
A: When copying in a one-sided to two-sided mode:
Use the original to copy key to select the desired one-sided to two-sided
copying mode (Turn on Long Edge or Turn on Short Edge). See the
illustrations on page 52.
B: When copying in the two-sided to two-sided mode:
Use the original to copy key to select the two-sided to two-sided copying
mode. The originals must be set in the SPF/RSPF before this mode can
be set (step 3) on page 48 (AL-1555).
C: When copying in the two-sided to one-sided mode:
Use the original to copy key to select the two-sided to one-sided copying
mode. The originals must have been set in the SPF/RSPF in step 3 on
page 48 (AL-1555).
3
Select the copy settings. See "SET THE COPY QUANTITY"
(p.49), "EXPOSURE ADJUSTMENT/PHOTO COPYING" (p.49),
and "REDUCTION/ENLARGEMENT/ZOOM" (p.51).
Using the original table
If you are using the original table, copying is only possible in one sided to
two-sided mode ("A" above).
1
Press the start ( ) key.
The original is scanned into the unit's memory.
2
Place the original that you wish to copy onto the rear side of the
paper, and press the start ( ) key again.
Copying begins.
Using the SPF/RSPF
Press the start ( ) key. Copying begins in the selected two-sided copy mode.
A B
A
AL-1552_AL-1553
AL-1555
C
To Next Page
Loading...
