63
8
MISFEED REMOVAL
When the misfeed ( ) indicator blinks or blinks in the display, the unit will
stop because of a misfeed. If a misfeed occurs when using the SPF/RSPF, a number
may appear in the display after a minus sign. This indicates the number of the
originals that must be returned to the original feeder tray after a misfeed. Return the
required number of originals. Then this number will disappear when copying is
resumed or the clear ( ) key is pressed. When the SPF/RSPF misfeeds an
original sheet, the unit will stop and the SPF/RSPF misfeed ( ) indicator will blink,
while the misfeed ( ) indicator will remain off. For a misfeed of originals in the SPF/
RSPF, see "E: Misfeed in the SPF (AL-1553), RSPF (AL1555)" (p.66).
1
Open the multi-bypass tray (AL-1553, AL-1555), and side
cover, in that order.
To open the multi-bypass tray, see "The multi-bypass tray (AL-1553, AL-
1555)" (p.17). To open the side cover, see "INSTALLING THE TD
CARTRIDGE" (p.10).
2
Check the misfeed location. Remove the misfed paper
following the instructions for each location in the illustration
below. If the misfeed ( ) indicator blinks, proceed to "A:
Misfeed in the paper feed area" (p.64).
If paper is misfed here, proceed to "A:
Misfeed in the paper feed area". (p.64)
If paper is misfed here, proceed
to "D: Misfeed in the lower
paper feed area". (p.66)
If paper is misfed here, proceed to "B:
Misfeed in the fusing area". (p.64)
If the misfed paper is seen from
this side, proceed to "C: Misfeed
in the transport area". (p.65)
To Next Page
Loading...
