28
Watching TV
Auto power-off at a designated time
This function is conveniently used when, for instance,
going to bed while watching TV.
1
2
Sleep timer: Remain 2hr. 00min.
NOTE
• When the time has been set, countdown automatically
starts.
• Five minutes before the preset of time expires, the
remaining time displays each minute.
• Select “Off” by pressing SLEEP to cancel the sleep timer.
Press SLEEP.
• Remaining time displays when sleep timer has
been set.
Each time you press SLEEP, the remaining
time switches as shown below.
0hr. 30min. 1hr. 00min. 1hr. 30min.
2hr. 30min. 2hr. 00min.
Off
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “Power Control”.
2
Press
a
/
b
to select “No Signal Off”, and then
press ENTER.
3
Press
a
/
b
to select “Enable”.
• Five minutes before the power shuts down, the
remaining time displays every minute.
4
Press MENU and the MENU screen displays.
1
Press
c
/
d
to select “Power Control”.
2
Press
a
/
b
to select “No Operation Off”, and
then press ENTER.
3
Press
a
/
b
to select “30 min” or “3 hour”.
• Five minutes before the power shuts down, the
remaining time displays every minute.
4
NOTE
• “Disable” is the factory preset value.
Auto power-off when there are no
operations performed
You can set the TV to automatically power off when no
TV operation is performed for more than 3 hours.
NOTE
• “Disable” is the factory preset value.
• When a TV programme fi nishes, and the TV receives signal
input, this function may not operate.
Auto power-off after the end of broadcast
You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving
no programme signals, such as the end of a broadcast
day.
Energy conservation settings
32A33X_en_d.indd 2832A33X_en_d.indd 28 2008-1-4 20:14:402008-1-4 20:14:40
To Next Page
Loading...
