Sharp Aquos LC-32A33X - Settings When Using External Devices; Settings When Using HDMI Output Devices; AQUOS LINK Setup; Audio Only

37
To watch an HDMI equipment image, select
“INPUT3” or “INPUT4” using direct key IN3
(HDMI), IN4 (HDMI), TV/VIDEO on the
remote control unit or TV/VIDEO on the TV.
1
Press MENU and the MENU screen displays.
2
Press
c
/
d
to select “Option”.
3
Press
a
/
b
to select “HDMI Setup”, and then
press ENTER.
• The HDMI Setup can be selected only when
“INPUT3” or “INPUT4” is selected.
4
MENU
[
Option
...
HDMI Setup
]
Option
Colour System
HDMI Setup
Fine Sync.
Game Play Time
Audio Only
Input Select
AQUOS LINK Setup
Output Volume Select
DNR
H
HDMI (High-Defi nition Multimedia Interface)
terminal selection
Press
a
/
b
to select the desired item, and
then press ENTER.
5
NOTE
• Refer to your external equipment operation manual for the
above settings.
• When connecting a DVI-HDMI conversion adaptor/cable to
the HDMI terminal, the image may not come in clearly.
• “Audio Select” is only available for INPUT3.
Co
nnecting an HDMI output device
Settings when using external devices
HDMI output
device
HDMI Setup
items
Selectable
items
Description
Auto View Enable/
Disable
Set whether or not to use
WIDE MODE based on
signal recognition, including
an HDMI signal.
Audio
Select
Digital/
Analogue
Select “Digital” for audio
signal via the HDMI terminal.
Select “Analogue” for audio
signal via the AUDIO jack.
Settings when using HDMI output devices
HDMI terminals can carry audio and visual signals to the TV with an HDMI certifi ed cable. When you want to output
the audio and picture from an HDMI output device on the TV, select “INPUT3” or “INPUT4” by switching the input
source.
HDMI cable (commercially available)
32A33X_en_f.indd 3732A33X_en_f.indd 37 2008-1-4 20:15:532008-1-4 20:15:53