Sharp Aquos LC-40LB700X

7
Preparation
Attaching the stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work, spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
Soft
cushion
Screw driver
(not supplied)
Long screw
Screw
driver
(not
supplied)
Short
screw
1
Confi rm the 8 screws supplied with the TV.
Short screws (
g
4)
(used in step 3)
Long screws (
g
4)
(used in step 2)
2
Attach the supporting post for the stand unit
onto the base as shown below.
3
1
Insert the stand into the openings on the
bottom of the TV.
2
Insert and tighten the 4 short screws into
the 4 holes on the rear of the TV.
1
1
NOTE
• To detach the stand, perform the steps in reverse order.
LC-40LB700X_en_b.indd 7LC-40LB700X_en_b.indd 7 8/7/2009 12:35:44 PM8/7/2009 12:35:44 PM