@-24
Basic adjustment settings
Channel memory setting
Press MENU
to
display the MENU screen,
and then press
......
/~
to select "Setup".
Press
./T
to
select "CH Setup", and then
press
ENTER.
•
If
you already set the Secret No., input the
4-digit secret number here. See page 40 for
setting a secret number.
Press
./T
to select "CH Memory", and then
press
ENTER.
Press
./T
to select ANALOG
(Air),
ANALOG
(Cable), DIGITAL
(Air)
or DIGITAL (Cable), and
then press
ENTER.
When viewing ANALOG broadcasts:
CD
Press
~/~
to select the channel to skip, and
then press
T
to
move down.
® Press
~/~
to select "On", and then press
ENTER.
When viewing DIGITAL broadcasts:
CD
Press ...
/T
to
select the channel to skip, and
then press
~/~
to
select "On".
• On: Skips channels. (Channel selection disabled using
CH
A/Y·)
• Off: Does not skip channels. (Channel selection enabled
using CH
A/Y.)
Press MENU
to
exit.
• Make sure what kind of connection
is
made with your
TV.
In
order to receive digital air broadcasts, you need a
digital broadcast antenna. You can confirm the antenna
configuration through the "Antenna Setup - DIGITAL"
screen.
If
necessary, adjust the direction of the antenna to
obtain the maximum signal strength.
Signal Strength
Press MENU
to
display the MENU screen,
and then press
.....
/~
to
select "Setup".
Press
./T
to select "Antenna Setup -
DIGITAL", and then press
ENTER.
Press
./T
to select "Signal Strength".
• The signal strength
of
DIGITAL channel
is
displayed. The signal information
is
based on
the current channel.
Press MENU to exit.
Channel Strength
The channel signal strength can also be checked
separately.
Repeat steps 1 and 2
in
Signal Strength
in
Antenna Setup - DIGITAL.
Press
./T
to select "Channel Strength",
and then press
ENTER.
Input the 2-digit channel number to check
the signal strength of the selected channel.
• Make sure the signal
is
strong enough for each
channel.
Press MENU to exit.
• This function
is
available for DIGITAL
(Air)
only.
To Next Page
Loading...
