Appendix
Before detaching (or attaching) stand, unplug the AC cord from the AC INPUT terminal.
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Before attaching/detaching stand
• Before performing work make sure to turn off the
lV.
• Before performing work spread cushioning over the base area
to
lay the
lV
on. This will prevent it from being
damaged.
1
Hex key
2
Unfasten the four screws used
to
secure the stand
in
place.
Detach the stand from the 1V.
(Hold the stand so it will not drop from the edge of the
base area.)
• To attach the stand, perform the above steps
in
reverse order.
• This TV should be mounted
on
the wall only with the AN-52AG1 (SHARP) wall mount bracket. The use of other
wall mount brackets may result
in
an unstable installation and may cause serious injuries.
• Installing the TV requires special skill that should only be performed by qualified service personnel. Customers
should not attempt to do the
work
themselves. SHARP bears no responsibility for improper mounting or
mounting that results
in
accident or injury.
Using an optional bracket to mount the TV
• You can ask a qualified service professional about using
an
optional AN-52AG1 bracket to mount the
1V
to the
wall.
• Carefully read the instructions that come with the bracket before beginning work.
CD
Angle
of
TV
0/5/10/15/20°
®
Height
-1
63/
64
(-
5)/0/
Adjustment
+ 1
63/
64
(
+
5)
• can be moved 1
63/
64
(5)
up or down
Unit: inch (cm)
About setting the TV angle and height adjustment
Angular mounting
Vertical mounting
Hanging on the wall
AN-52AG1 wall mount bracket.
(See the bracket instructions for details.)
• Detach the cable clamps on the rear of the
1V
when using the optional mount bracket.
@-so
To Next Page
Loading...
