Appendix
Problem
Possible Solution
• No power
• Check if you pressed
TV POWER on the remote control unit.
(See
page 16.)
If
the
indicator on the TV does not light up, press
POWER on the
TV.
•
Is
the AC cord disconnected?
(See
page
7.)
• Has the power been turned on?
(See
page 16.)
• Unit cannot be operated. • External influences such as lightning, static electricity, may cause improper
operation.
In
this case, operate the unit after first turning on the power
of
the TV or
unplugging the AC cord and replugging it
in
after 1 or 2 minutes.
• Remote control unit does not
•
Is
the FUNCTION set correctly? Set it to the TV setting position.
operate.
• Are batteries inserted with polarity (
+,
-)
aligned? (See page
8.)
• Are batteries worn out? (Replace with new batteries.)
• Are you using it under strong or fluorescent lighting?
•
Is
a fluorescent light illuminated near the remote control sensor?
• Picture
is
cut off/with sidebar •
Is
the image position correct?
(See
page 32.)
screen.
• Are screen mode adjustments such as picture size made correctly?
(See
pages 34
and 35.)
• Strange color, light color, or color
• Adjust the picture tone.
(See
pages 26 and 27.)
misalignment
•
Is
the room too bright? The picture may look dark
in
a room that
is
too bright.
• Check the input signal setting.
(See
page 37.)
• Power
is
suddenly turned off. •
Is
the sleep timer set?
(See
page 33.)
• Check the power control settings.
(See
page 29.)
• The unit's internal temperature has increased. Remove any objects blocking vent
or clean.
• No picture
•
Is
connection to other components correct? (See pages 13
to
15.)
•
Is
correct input signal source selected after connection? (See page 30.)
•
Is
the correct input selected?
(See
page 30.)
•
Is
picture adjustment correct?
(See
pages 26 and 27.)
•
Is
"On" selected
in
"Audio Only"?
(See
page 36.)
•
Is
a non-compatible signal being input?
(See
page 15.)
• No sound
•
Is
the volume
too
low?
(See
page 19.)
•
Is
"Variable" selected
in
"Output Select"?
(See
page 36.)
• Have you pressed MUTE on the remote control unit?
(See
page 19.)
The error message about reception of broadcast
The example of an error
Error code
Possible Solution
message displayed
on
a screen
• Failed to receive broadcast.
E202
• Check the antenna cable. Check that the antenna
is
correctly
setup.
• No broadcast now.
E203
• Check the broadcast time
in
the program guide.
Cautions regarding use
in
high and low temperature environments
• When the unit
is
used
in
a low temperature space (e.g. room, office), the picture may leave trails or appear slightly delayed.
This
is
not a malfunction, and the unit will recover when the temperature returns to normal.
• Do not leave the unit
in
a hot or cold location. Also, do not leave the unit
in
a location exposed to direct sunlight or near a
heater, as this may cause the cabinet
to
deform and the Liquid Crystal panel to malfunction.
Storage temperature: - 4°F
to
+ 140°F (- 20°C to + 60°C)
@-51
To Next Page
Loading...
