Supplied accessories
Make sure the following accessories are provided with the product.
Remote control unit
(x
1)
"AAA" size battery
(x
2)
Page 8
AC cord
(x
1)
Page 7
Cable Clamp
(x
2)
Cable tie
(x
1)
Page 7
Stand unit
(x
1)
Page 6
Operation manual
(x
1)
• Always use the AC cord supplied with the
TV.
• AC cord enclosed
in
this product
is
for
11
0-125V.
In
using
it
on the 125-240V AC, please consult to the following.
SHARP ELECTRONICS CORPORATION
6100 Blue Lagoon Drive, Suite 230, Miami, Florida 33126, U.S.A.
QUICK REFERENCE
• Before attaching
(or
detaching) the stand, unplug the AC cord from the AC INPUT terminal.
•
Before
performing
vv'ork
spread cushioning
over
the
base
area
to
lay
the
1V
on.
This
will
prevent
it
from
being
damaged.
• To detach the stand, perform the steps
in
reverse order.
Attach the two supporting posts for the stand
unit onto the base using the box for the stand
unit as shown below.
(Close-up of the upper side of the stand unit)
Confirm that there are 10 screws
(6
short
screws and 4 long screws) supplied with the
stand unit.
• Attach the stand
in
the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result
in
the TV falling over.
CD
Insert the stand into the openings on the
bottom of the
TV.
® Insert and tighten the 4 long screws into
the 4 holes on the rear of the
TV.
1
~
Insert each of the protrusions on the two supporting
posts into the openings on the upper side of the
base.
2 Insert and tighten the 6 short screws with the hex
key (supplied with the product)
in
the order of
CD,
@-6
® and @.
To Next Page
Loading...
