30
TV Start-up time setting
View setting
Quick start
You can reduce the TV’s start-up time after turning on
the power with the remote control unit.
Go to “Menu” > “Setup” > “View setting” > “Quick
start”.
Item
On
The TV quickly starts up from standby.
22 W or more of power consumption is
required during standby.
Off
Power consumption is small during
standby.
Individual setting-Password
View setting
Password
Allows you to use a password to protect certain settings
from being accidentally changed.
Go to “Menu” > “Setup” > “View setting” >
“Individual setting” > “Password”
.
E
Setting a password
Register a four-digit password number to use the
“Password” function.
1 If you already set the password, enter it here.
2 Press c/d to select “Yes”, and then press
A.
3 Enter the four-digit number as a password using
0_9 numeric buttons.
Password
Yes No
Setting Password. You can change or
clear Password
Enter your new password.
Use 4 digits
Enter the password again to confirm
4 Enter the same four-digit number as in step 3 to
confirm.
5 Press A.
NOTE
• To view a locked channel, you must enter the password (see
page 29 for locking channels password). When you select a
locked channel, a password prompt message pops up. Press
C to display the password input window.
E
Deleting the password
Allows you to reset your password.
1 Enter the password.
2 Press c/d to select “No”, and then press
C.
3 Press c/d to select “Yes”, and then press
A.
Password
Yes No
Delete password?
NOTE
• As a precautionary measure, make a note of your
password on page 54, cut it out and keep it in a safe
place that children cannot reach.
• This function is only available for TV input mode.
• To relock a channel which has been temporarily unlocked by
inputting the correct password, turn power off and then on
again.
Individual setting-Time
View setting
Time display
Go to “Menu” > “Setup” > “View setting” >
“Individual setting” > “Time display”.
Time display
This function allows you to display the clock time in the
lower-right corner of the screen.
Item
On
Displays the clock time.
On (half-hourly)
Displays the clock time in 30-minute
increments.
Off
Hides the clock time.
NOTE
• Time information is available when channel time information
including the teletext information is obtained in the “TV”
mode.
Time format
You can select the time format (either “24HR” or “AM/
PM”) for the clock time.
NOTE
• The displayed time may differ depending on the programmes
because of the programme information.
Useful viewing functions
To Next Page
Loading...
