Specifications
Wireless LAN
This TV has received the following certifications.
-
Wi-Fi
CERTIFIEDâ„¢
(certification program from
the
Wi-Fi
Alliance")
-
Wi-Fi
Protected
SetupTM
(certification program
from
the
Wi-Fi
Alliance'")
FCC
This
device complies with part 15 of the
FCC
Rules.
Operation
is
subject
to
the following two conditions:
(1)
This device may not
cause
harmful
interference,
and
(2)
this device must accept any interference
received,
including
interference that may cause undesired operation. Changes or modifications not expressly approved by the party
responsible for compliance could
void
the user's authority to operate the equipment.
To
comply with the
FCC
RF
exposure compliance requirements, this device
and
its
antenna must not be co-located or operated
in
conjunction
with any other antenna or transmitter.
The
device for the band 5150-5250 MHz
is
only for indoor
usage
to reduce potential for harmful interference to co-
channel mobile satellite systems;
The
maximum antenna
gain
permitted
(for
devices
in
the bands 5250-5350 MHz and 5470-5725
MHz)
to comply with
the e.i.r.p.
limit; and High-power radars
are
allocated
as
primary
users
(meaning they
have
priority)
of the bands 5250-
5350
MHz and 5650-5850
MHz
and these radars could cause interference and/or damage to
lE-lAN
devices.
COFETEL
This
equipment operates
on
a secondary
basis
and,
consequently, must accept harmful interference, including
from
station
of
the
same
kind, and may not cause
harmful
interference to systems operating
on
a primary
basis.
CONTAINS
TRANSMITTER
MODULE
COFETEL
ID:
RCPSHTW11-1252
Brand:
SHARP
Model: TWFM-B005D
Specification
Standard
IEEE
802.11
alb/gin
Frequency Band
2412-2484
MHz
5150-5850
MHz
Static
WEP
(64/128 bit
key
Index 1
only)
Security
WPA-PSK
(TKIP)
WPA2-PSK
(AES)
DBPSK@1
Mbps
DQPSK@2Mbps
CCK@5.5/11
Mbps
Modulation
BPSK@6/9
Mbps
QPSK@12/18Mbps
16-QAM@24Mbps
64-QAM@48/54Mbps and above,
Rx
up
to 300Mbps
®-54
Bluetooth
IMPORTANT SAFETY INSTRUCTIONS
Notes on Radio Wave Certification in the U.S.A. and Canada
This
device complies with part
15
of the
FCC
Rules.
Operation
is
subject to the following two conditions:
(1)
This
device
may
not
cause
harmful
interference, and
(2)
this device must accept
any
interference
received,
including
interference that
may
cause
undesired operation.
"This
transmitter must not
be
co-located or operated
in
conjunction with
any
other anntenna or transmitter."
FCC/INDUSTRY
CANADA
NOTICE
This device complies
with
Part
15
of
FCC
Rules
and Industry Canada license-exempt
RSS
standard(s).
Operation
is
subject to the following two conditions:
(1)
this device may not cause interference,
and
(2)
this device must accept
any
interference, including interference that
may
cause undesired operation of this device.
This equipment complies with
FCC/IC
radiation exposure limits set forth for
an
uncontrolled environment
and
meets
the
FCC
radio frequency
(RF)
Exposure Guidelines
in
Supplement C to
OET65
and
RSS-1
02
of the
IC
radio frequency
(RF)
Exprosure
rules.
This
equipment
has
very
low
levels
of
RF
energy that
are
deemed to comply without testing of
specific absorption ratio
(SAR).
FCC
CAUTION
Changes or modifications not expressly approved
by
Hosiden responsible for compliance could
void
the user's
authority to operate the equipment.
Note:
This
equipment
has
been
tested
and
found to comply with the limits for a
Class
B digital device, pursuant to
Part
15
of the
FCC
Rules.
These
limits
are
designed to provide reasonable protection against
harmful
interference
in
a residential installation.
This
equipment generates, uses
and
can
radiate radio frequency
energy
and,
if not installed
and used
in
accordance with the instructions, may cause harmful interference to radio communications. However,
there
is
no
guarantee that interference
will
not occur
in
a particular installation.
If
this equipment does cause
harmful
interference to
radio
or
television
reception, which can be determined by turning the equipment off
and
on,
the user
is
encouraged to try to correct the interference by one or more of the following
measures:
_
Reorient
or relocate the
receiving
antenna.
_Increase
the separation between the equipment
and
receiver.
_Connect
the equipment into
an
outlet
on
a circuit different from that to which the receiver
is
connected.
_ Consult the dealer or
an
experienced radio/TV technician for help.
This
Class
B digital apparatus complies with Canadian ICES-003
Le
present appareil est conforme
aux
Ia
prtie 15 des
regles
de
Ia
FCC
et
CNR
d'lndustrie
Canada
applicables
aux
appareils radio exempts
de
licence.
L'exploitation est autorisee aux deux conditions suivantes:
(1)
l'appareil
ne
doit
pas produire de brouillage,
et
(2)
l'uitilisateur de l'appareil doit accepter tout brouillage radioelectrique
subi,
meme
si
le
brouillage est susceptible d'en compromettre
le
fonctionnement.
Get equipement est conforme
aux
limites d'exposition aux rayonnements enoncees pour
un
environnement
non
controle
et
respecte
les
regles
les
radioelectriques
(RF)
de
Ia
FCC
lignes directrices d'exposition dans
le
Supplement C
a
OET65
et d'exposition
aux
frequences radioelectriques
(RF)
CNR-1
02
de I'IC.
Get
equipement emet
une
energie
RF
tres faible qui est consideree conforme
sans
evaluation
du
debit d'absorption specifique
(DAS).
Get appareil numerique de
Ia
classe
B est conforme a
Ia
norme NMB-3 du
Canada.
Notas sobre Ia Certificaci6n
de
Radiodifusion en Mexico
COFETEL:
RCPSHDB12-1487
Nombre de
Ia
marca
del
modulo con licencia: SHARP
CORPORATION
Nombre
de
modele
del
modulo con
licencia:
DBUB-S705
Modulo ARC0517 instalado adentro de esta gafas
PRECAUCI6N
"La
operacion de este equipo esta sujeta a
las
siguientes des condiciones:
(1)
es
posible que este equipo o dispositive
no cause interferencia
pe~udicial
y
(2)
este equipo o dispositive debe aceptar cualquier interferencia, incluyendo
Ia
que
pueda causar
su
operacion no deseada.'
Numero
de
licencia
para
Ia
certificaci6n
de
radiodifusi6n
Estados Unidos
CONTAINS
FCC
ID:
VIYARC0517
Canada
CONTAINS
IC:
7305A-ARC0517
Specification
Ver.
name
I
Ver.
3.0+EDR
profile
name
I
HID
To Next Page
Loading...
