Sharp AQUOS sense3

90
Call/Phonebook
4 Switch to video
z
Switch to a video call.
5 Add call/Swap
z
Place a current call on hold and make a call to another party.
z
Touch [Swap] after adding a call to switch the call party.
z
Subscription to Call Waiting Service is required to add a call.
6 End call
z
End a call.
7 Speaker/Sound
z
You can talk with hands-free.
z
Set the audio output destination when a Bluetooth device is
connected.
8 Hold
z
Hold a call. To unhold a call, touch again.
z
Subscription to Call Waiting Service is required to use hold.
9 Switch camera
z
Switch to the front camera/standard camera.
a Your own image
b The other party's image
z
Note the followings to use hands-free or video call.
y
Speak approximately 20 to 40 cm away from the mouthpiece.
When the surroundings are noisy, the sound may break up
and the call may not be satisfactory.
y
When calling outdoors, in a location where surroundings are
noisy or where the sound echoes loudly, use an earphone/
microphone.
y
If the sound breaks up during a hands-free call, lower the
in-call volume.

Adjusting the in-call volume
1
1/2 during a call

Switching to voice call
Switch to a voice call during a video call.
1
[ ] during a call▶[Switch to voice call]

Switching image area
Switch displaying area of the other party's/your own image during a
video call.
1
[ ] during a call▶[Switch video area]

Voice memo
Record a voice memo during a voice call.
1
[ ] during a call▶[Voice Memo]
2
[Stop]