Setting an access point
An access point (sp-mode) for Internet connection is
registered by default. You can add other access points
and change them if necessary.
For details of sp-mode, refer to the NTT DOCOMO
website.
(
https://www.nttdocomo.co.jp/service/spmode/ (in
Japanese only)
)
If you want to use mopera U or Business mopera Internet,
add an access point of either provider manually.
For details on mopera U, refer to the mopera U website.
(
https://www.mopera.net/ (in Japanese only)
)
1
z
z
You can check an access point in use.
2
z
3
4
5
z
z
Never set the MCC to a figure other than 440 or
the MNC to a figure other than 10. Otherwise the
added access point disappears from the screen.
z
If the settings of MCC and MNC are changed and the
added access point disappears from the screen, reset
the settings or set the access point manually.
Resetting an access point
Return the access point settings to the initial state.
1
z
2
z
z
When sp-mode is not subscribed or if you fail to make
automatic setting of an access point due to signal
status such as outside the service area, you are
required to set the access point again manually.
Data usage
You can check the data usage volume via mobile
networks or Wi-Fi networks. Also, you can set limit.
1
z
z
The data communication volume via mobile
networks is displayed.
160
Handset Settings
To Next Page
Loading...
