13
Before Using the Handset
SH-04F_E_02.fm
[13/27]
2
Hold the docomo mini UIM card with the IC
(gold) side turned up and insert it slowly into
the docomo mini UIM card slot
: Push it slowly towards inside until a click is heard.
: Do not insert the docomo mini UIM card at an angle or with
the wrong side up. The docomo mini UIM card slot may be
damaged.
3
Close the docomo mini UIM card/microSD Card
slot cover
: To prevent gaps from being left between the handset and the
docomo mini UIM card/microSD Card slot cover, close it in
the direction of the arrow (1) and push the A areas
securely (2).
■ Removing docomo mini UIM card
1
Open the docomo mini UIM card/microSD Card
slot cover
2
Gently push the docomo mini UIM card towards
inside (1)
: Push it towards inside until a click is heard. It will come out
towards you.
3
Remove the docomo mini UIM card (2)
: Remove the docomo mini UIM card by slowly pulling it
straight out. Do not let it fall.
4
Close the docomo mini UIM card/microSD Card
slot cover
The internal battery is not fully charged at the time of
purchase. Be sure to charge the battery before use.
■ Cautions while charging
For details on the estimated charge time nP. 90 “Main
specifications”
The battery can also be charged with the handset turned on
(While charging, the battery icon appears with [w]
superimposed).
Do not charge for a long time with the power left turned on. If the
handset is left turned on after charging is complete, the internal
battery charge level decreases.
In this case, an AC or DC adapter (sold separately) charges the
battery again. However, depending on the time when the
handset is disconnected from the AC or DC adapter, the battery
charge level may be low or the battery may only be usable for a
short time.
If the handset is left for a long time even after the charging is
completed, the battery level may decrease.
When the battery is empty and the handset is being charged, the
charging lamp may not illuminate immediately. However,
charging is in progress.
If the battery empty alert is displayed and the power cannot be
turned on, charge the battery for a while.
While charging, the handset may not turn on even when the
charging lamp is illuminated in red. Charge longer and try turning
power on again.
Frequently recharging the battery when its power is still
remaining enough may shorten the usable life of the internal
battery. It is recommended to use the battery to a certain level
(e.g. after the battery level decreases) before recharging.
When the battery becomes warm, charging may automatically
stop even if the battery has not been fully charged. Charging
automatically resumes after the temperature lowers to an
appropriate temperature.
If you watch Mobacas, receive contents, etc. while charging,
move the handset as far away as possible from the power plug
section of the AC adapter.
Notch
IC (gold)
docomo mini UIM
card slot (back side)
Notch
Make sure not to touch or damage the IC (gold) of the docomo
mini UIM card when handling it. Also, note that inserting or
removing the docomo mini UIM card forcibly may damage it.
Refer to the docomo mini UIM card user’s guide for more
information on the docomo mini UIM card.
Do not misplace the docomo mini UIM card once it is removed.
IMEI plate
A plate on which the IMEI number (International Mobile
Equipment Identifier) is printed is stowed near the docomo mini
UIM card slot. The IMEI number is required when you contact a
repair counter that DOCOMO specifies, so do not pull it out.
Note that pulling the IMEI plate forcibly or adding forces on it
may damage the plate.
If you accidentally pull out the IMEI plate, push it back slowly
towards inside.
Charging
SH-04F_E.book 13 ページ ２０１４年５月１９日 月曜日 午後３時５０分
To Next Page
Loading...
