15
MAKING COPIES
NORMAL COPYING
Normal copying
●
For manual copy density adjustment, press the AUTO/MANUAL/
PHOTO (
/ / ) key to select MANUAL ( ) and adjust
with the light (
) and dark ( ) keys as desired.
●
For photographs, select PHOTO (
) and then adjust with the light
(
) and dark ( ) keys as desired.
●
There are 5 exposure steps indicated by 3 indicator lights. (The
indicators light up one or two at a time.)
If exposure level 2 is selected, the two left-handmost indicators for that
level will light up simultaneously. Also, if level 4 is selected, the two
right-handmost indicators for that level will light up simultaneously.
6
Set the number of copies using the numeric keys.
●
A single copy can be made with the initial setting, i.e., when “0” is
displayed.
●
Press the CLEAR (
) key to clear an entry if a mistake is made.
7
Press the START (
) key.
●
The number in the copy quantity display will decrease by 1 each time
a copy is made.
●
Press the CLEAR (
) key to stop copying in the middle of a run.
●
To repeat the same copy sequence for a different original, simply
replace the original and press the START (
) key.
●
If the paper in the paper tray runs out during the copy run , the bypass
tray can be selected using the TRAY SELECT (
) key.
How to remove the platen cover
The platen cover can be removed to allow copying of
bulky objects. To remove it, simply lift the platen cover
straight up.
●
To reattach the platen cover, reverse the above procedure.
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
