14
MAKING COPIES
5
Adjust the copy density.
●
This copier has three exposure modes to choose from — AUTOMATIC
(
), MANUAL ( ), and PHOTO ( ).
●
Automatic exposure is the standard initial setting for this copier. In this
mode, the characteristics of the original are “read” by the exposure
system and adjustments are automatically made. This optimizes the
contrast of the copied images by reducing the effect of coloured or
shaded background areas. See page 26 to adjust the automatic expo-
sure level.
NORMAL COPYING
1
Turn the power switch on.
●
It will take about 35 seconds for the copier to warm up. However, you
can make desired settings and press the START (
) key during
warm-up. Copying will start after warm-up.
●
If the copier has been programmed in the auditing mode, the START
key (
) indicator will not light up and “–––” will appear in the copy
quantity display. Enter an assigned 3-digit account number. See page
13.
●
If the power is already on and all indicators except the POWER SAVE
(
) indicator are off, the copier is in the auto power shut-off mode.
Press the START (
) key in this case. See page 42, POWER SAVE
MODES.
2
Place the original face down on the original table. Align
it with the original size scale.
●
Image loss (max. 4 mm (5/32")) can occur at the leading and trailing
edges of the copies. Also image loss (max. 4 mm (5/32") in total) can
occur along the other edges of the copies.
3
Close the platen cover.
4
Ensure that the copy paper size in the paper tray is the
same size as the original.
●
If paper of the required size is not loaded in the paper tray, use the
bypass tray and press the TRAY SELECT (
) key to select the
bypass tray.
Normal copying
Power on
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
