Main Sub
Item Content
Adjustment
code code range
43 01 Sets fusing
temperature
(normal mode).
[Content] The current setting of fusing temperature in the normal mode is displayed and a
new setting can be entered.
(a) Operation/display
[PRINT]: If the entered value is valid, the current setting is updated and the screen
changes to the sub code input screen.
If the entered value is not valid, the input field is cleared and the error
buzzer sounds. If any value is not entered, the setting is not updated and
the screen changes to the sub code input screen.
[0-9]: Enters fusing temperature settings.
[C]: Clears the input field.
[PAUSE]: No setting is made and the sub code input screen is displayed.
[CA]: The execution of the simulation is stopped and the simulation is terminated.
02 Sets fusing
temperature (in
economy mode).
0-45SIMULATION NO.43- 2
FUSER TEMPERATURE SETUP (ECONOMY MODE)
MARGIN TO NORMAL MODE [-XXX]:_ °C
- 0°C , -25°C
- 5°C , -30°C
-10°C , -35°C
-15°C , -40°C
-20°C , -45°C
ATTENTION, CAN NOT SET 150°C OR_LESS
INPUT SETUP VALUE AND PRESS PRINT SW
[Content] The current setting of the fusing temperature in the economy mode is displayed
and a new setting can be set.
(a) Operation/display
[PRINT]: If the entered value is valid, the current setting is updated and the screen
changes to the sub code input screen.
If the entered value is not valid, the input field is cleared and the error
buzzer sounds. If any value is not entered, the setting is not updated and
the screen changes to the sub code input screen.
[0-9]: Enters fusing temperature settings.
[C]: Clears the input field.
[PAUSE]: No setting is made and the sub code input screen is displayed.
[CA]: The execution of the simulation is stopped and the simulation is terminated.
44 Sets process
control mode.
SIMULATION NO.44- _
1.PROCESS CONTROL MODE SETUP
2.DM SENSOR ADJUSTMENT
3.ID SENSOR ADJUSTMENT
4.PROCESS CONTROL INITIAL DENSITY
SETUP
7.DM/ID SENSOR GAIN CHECK
9.PROCESS CONTROL DATA DISPLAY
12.DM/ID PATCH, DRUM BASE OUTPUT
DISPLAY
INPUT SUB NO. AND PRESS PRINT SWITCH
9 – 61
To Next Page
Loading...
