9 Remove the pick-up roller from the drive roller shaft assembly.
F Remove the paper feed roller from the drive roller shaft assembly.
3. Paper feed unit
(1) Paper feed roller and pick-up roller
1 Remove the spring clutch harness.
2 Remove a screw and the E-ring.
3 Displace the shaft toward the clutch until the pick-up roller lever
clears the frame.
4 Remove the E ring.
5 Remove the pick-up roller lever.
6 Remove both the paper feed roller and the pick-up roller.
Note: The paper feed roller should be installed so that the one-way
clutch is pointed toward the rear frame (clutch side).
The pick-up roller should be installed so that the projection is
pointed toward the rear frame.
(2) Separation roller
1 Remove the pressure spring.
2 Displace the shaft (with the gear).
3 Remove the separation roller.
Note: The reverse roller should be installed so that the projection is
pointed to toward the rear frame.
Pick-up roller
Paper feed roller
E ring
Screw
E ring
Pick-up roller lever
Paper feed roller
Pick-up roller
Pressure spring
Separation roller
7 – 3
To Next Page
Loading...
