12. RADF
(1) Transport section opening
1 Loosen screws which are fixing the hinge stopper to allow the
hinge stopper to move.
2 Slide the hinge stopper downward by using the step screw, fit the
dove with the hole and tighten the fixing screws which were
loosen before.
3 Open the transport section.
(2) Belt unit disassembly
1 Open the transport section.
2 Remove screws as shown in the figure below, and remove the
belt unit as shown with arrow A and arrow B in this sequence.
(3) Paper feed unit disassembly
1 Open the transport section.
2 Remove the tray.
3 Remove screws which are fixing the lower cover, and remove the
lower cover.
4 Remove the fixing screws of the paper feed unit, open the paper
feed cover, and remove the fixing screw.
Screw
Hinge stopper (Move down.)
Screw
Belt unit
A
B
Paper feed unit
Paper feed
cover
Paper feed unit
fixing screw
Paper feed unit
fixing screws
Lower cover
7 – 16
To Next Page
Loading...
