110
TROUBLESHOOTING
The START indicator is
not lit in the USB
Memory Scan mode.
The USB memory is not recognized or not inserted, or any device
other than USB memory is inserted in the USB port.
→ Check the USB port of the Network expansion kit.
–
"ERR" appears in the
display during USB
Memory Scan.
Any device other than USB memory is inserted in the USB port, the
USB memory is write-protected, or it was taken off during USB
Memory Scan.
→ Check your USB memory device and use it properly.
–
"FUL" appears in the
display during USB
Memory Scan.
The memory of the USB device became full.
→ Use the USB device with sufficient memory.
–
Problem Cause and solution Page
To Next Page
Loading...
