111
7
INDICATORS AND DISPLAY MESSAGES
If one of the following indicators lights up or one of the following messages appears in the display, check the
meaning of the indicator or message in the following table and take appropriate action.
Indication Cause and solution Page
Maintenance indicator Steadily lit
Service by an authorised SHARP service technician is
required.
–
Developer
replacement required
indicator
Steadily lit
Developer is required. Contact your authorised service
representative.
–
Toner cartridge
replacement required
indicator
Steadily lit
Replacement of toner cartridge will be needed soon.
Prepare a new cartridge.
–
Blinking
• Toner cartridge must be replaced. Replace it with a
new one.
• Toner is being fed.
119
Misfeed indicator Blinking
A paper misfeed has occurred. Remove the misfeed as
explained in "MISFEED REMOVAL".
112
Paper required
indicator
Steadily lit
The tray is out of paper. Load paper. It is also possible
that the tray is not inserted completely into the
machine. Make sure it is inserted correctly.
39
ORIGINAL SIZE indicator Blinking
The original is not placed in the correct orientation.
Rotate the original so that it is in the same orientation
as the blinking ORIGINAL SIZE indicator.
44,45
PAPER SIZE indicator Blinking
A blinking PAPER SIZE indicator means that the size
of paper loaded in the tray is different from the paper
size setting for the tray. Change the paper size setting.
To clear the display, do one of the following:
• Use the [TRAY] key to change the tray selection.
• Open and close the tray.
• Press the [CLEAR ALL] key ( ).
41
[CH] appears in the number of
copies display
Steadily lit
The front cover or the side cover is open. Close the
front cover or the side cover.
–
Blinking
The toner cartridge is not installed correctly. Reinstall
the toner cartridge. If [CH] still blinks in the display after
reinstalling the toner cartridge, contact your authorised
service representative.
119
Letters and numbers appear in the
display
Turn off the power switch, wait about 10 seconds, and
then turn on the switch again. If this does not clear the
message, write down the code (Main code and sub
code exists.) that appears and then unplug the power
cord and contact your authorised service
representative. Tell your authorised service
representative what code appeared and the
circumstances under which it appeared.
–
"FUL" appears in the display
Data is being held in memory. Print the data or clear it
from memory.
60, 62
When "Use close paper size" is disabled
Press the [TRAY] key to manually select the tray and
then press the [ONLINE] key ( ). Printing will begin.
If you are selecting the bypass tray, load paper in the
bypass tray.
67
Misfeed location indicator lights up at the
optional 500-sheet paper feed unit
The side cover of the 500-sheet paper feed unit is
open. Close the side cover.
–
To Next Page
Loading...
Need help?
General
