AR-6020V SIMULATIONS 6-1
[6] SIMULATIONS
1. General
Perform the following procedure to enter the simulation mode.
"#" key Interrupt key CLEAR key ( ) Interrupt key
Main code [START] key Sub code [START] key
When the CLEAR ALL key is pressed, the simulation mode is cancelled.
When the INTERRUPT key is pressed, the process is interrupted and
the screen returns to the sub code entering display.
* After canceling the simulation mode, be sure to turn OFF/ON the
power and check the operation.
Note: If the machine is stopped by a misfeed or paper empty while in the
simulation mode or adjustment, the simulation / adjustment must
be restarted.
2. List of simulations
Main
code
Sub
code
Contents
01
01 Mirror scanning operation
02 Mirror home position sensor (MHPS) status display
05 Mirror scanning operation aging
02
01 Reversing single pass feeder (RSPF) aging
02 RSPF sensor status display
03 RSPF motor operation check
08 RSPF paper feed solenoid operation check
09 RSPF reverse solenoid operation check
11 RSPF PS release solenoid operation check
04
02
<20/23 CPM> Used to display the state of the sensors in the
desk.
<26/31 CPM> Used to display the status of the cassette/desk
sensor.
03 Used to check the operations of the motor in the desk.
07
<20/23 CPM> Used to check the operations of the lift up motor
in the desk.
<26/31 CPM> Used to check the operations of the cassette/
desk lift up motor.
08
<20/23 CPM> Used to check the operations of the paper feed
clutch in the desk.
<26/31 CPM> Used to check the operations of the cassette/
desk paper feed clutch.
09
Used to check the operations of the paper transport clutch in
the desk.
05
01 Operation panel display check
02 Fusing lamp operation check
03 Copy lamp lighting check
06
01 Paper feed solenoid/clutch operation check
02 Resist roller solenoid/clutch operation check
03
<26/31 CPM only> Used to check the operations of the
separate pawl.
20 Used to check the operations of the paper feed clutch.
21 Used to check the operations of the PS clutch.
22 Used to check the operations of the manual paper feed clutch.
07
01 Warm-up display and aging with jam
06 Intermittent aging
08
01 Developing bias output
02 Main charger output
06 Transfer setting and output
09
01 Duplex motor forward rotation check
02 Duplex motor reverse rotation check
04 Duplex motor RPM adjustment
05 Duplex motor switchback time adjustment
10 01 Toner motor operation
14 - Trouble cancel (except for U2)
16 - U2 trouble cancel
20 01 Maintenance counter clear
21
01 Maintenance cycle setting
02 Mini maintenance cycle setting
1
: ‘19/Oct.
1
1
To Next Page
Loading...
