Sharp AR-6023DV

AR-6020V DISASSEMBLY AND ASSEMBLY 10 – 2
2. Disassembly and assembly of each
unit
A. High voltage section/Duplex transport section
(1) Transfer roller unit
Open the bypass tray and remove the side door.
Remove the transfer roller unit.
(2) Transfer roller
Open the pawls. Remove the transfer roller unit. Then, remove the
E-ring, the TC roller collar, the transfer roller gear, the transfer roller
bearing R and the pin from the transfer roller.
* When the transfer roller unit is fixed to the right door unit, check
that the high pressure spring of the transfer roller unit fits with the
right door unit.
(3) Duplex transport part
Remove the rail inner unit.
Remove the side door reinforcing plate.
Remove the side door auxiliary roller.
No. Content
1 Transfer roller unit
2 Transfer roller
3 Duplex transport part
(1)
(2)
(3)
(1)
(2)
(3)
(3)
(1)
(2)
(1)