CONVENIENT COPY FUNCTIONS
28
Using the SPF/RSPF
1
Place the original(s) in the SPF/RSPF. (p.21)
If you place an odd number of originals for one-sided to two-sided copying,
the last page will be one-sided.
2
Press the [2-SIDED COPY ( )] key and
select the two-sided copy mode that you
wish to use.
The mode changes as follows each time you press
the [2-SIDED COPY ( )] key: "1 TO 1", "1 TO
2", "2 TO 2", "2 TO 1"
• Two-sided copies from one-sided originals: "1 TO 2"
• Two-sided copies from two-sided originals: "2 TO 2"*
• One-sided copies from two-sided originals: "2 TO 1"*
* When the RSPF is installed.
3
Press the [OK] key.
If you selected "1 TO 2" in step 2, select "LONG EDGE" or "SHORT EDGE"
and press the [OK] key. LONG EDGE and SHORT EDGE are shown in the
illustration on page 26.
4
If you
selec
ted "2
TO 1" or "2 TO 2", press the [ ] key ( )
or [ ] key ( ) to select the original size
and then press the [OK] key.
The following original sizes can be selected:
"A4", "B5", "A5", "8.5x14", "8.5x13", "8.5x11",
"5.5x8.5".
5
Select the number of copies and any other settings, and then
press the [START] key ( ).
The copy will be delivered to the paper output tray.
• To cancel automatic two-sided copying, press the [CLEAR ALL] key
( ) or press the [2-SIDED COPY ( )] key, select the "1 TO 1",
and then press the [OK] key.
• Do not touch the reversing tray while automatic two-sided copying is
in progress. (When the RSPF is installed.)
To Next Page
Loading...
