SET UP THE SOFTWARE
47
5
5
When you are asked how
the printer is connected,
select "Connected to this
computer" and click the
"Next" button.
If you are using the machine as
a shared printer on a network,
select "Connected via the
network". For more information
on this setting, see "Using the
machine as a shared printer"
(p.48).
6
When the interface
selection screen appears,
select "Parallel" and click
the "Next" button.
7
Select the printer port and
whether the machine is to
be used as the default
printer, make the
selections and click the
"Next" button.
Select "LPT1" for the printer
port.
• If "LPT1" does not appear, another printer or peripheral device is
using LPT1. In this case continue the installation, and after the
installation is finished, change the port setting so that the machine
can use LPT1. This procedure is explained in "Another printer is
using the parallel port (when using a parallel cable)" on page 77.
• The "Add Network port" button is used when the machine is used as
a shared printer. (p.48) Do not click this button here.
Note
To Next Page
Loading...
