E-17
ENGLISH
CD-G14000
CD-G17000
CD-G22000
2008/April/25 CD-G14000/17000/22000
Preparation for Use
Notes concerning use:
Replace the batteries if the operating distance is reduced or if the
operation becomes erratic.
Periodically clean the transmitter on the remote control and the
sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may interfere with
operation. Change the lighting or the direction of the unit.
Keep the remote control away from moisture, heat, shock, and
vibrations.
Test of the remote control
Check the remote control after checking all the connections (see
pages 9 - 16).
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you
can enjoy the music.
Subwoofer control
Power switch
Press the POWER ON/OFF button to turn on the active subwoofer.
Volume control
Turn the VOLUME control clockwise to increase the volume, and turn
it anti-clockwise to decrease the volume.
Crossover frequency control
Adjust the high frequency cut-off point. Frequencies higher than the
set frequency are removed.
To emphasise the bass, turn this control towards 35 Hz and increase
the volume.
TIMER
POWER
ON/ STAND-BY
CD
TUNER
(BAND)
4
3
1
5
4
5
3
2
1
PRESET
TUNING
PRESET
TUNING
VOL.
VOL.
PHONES
RECORD/PLAYBACK
PLAYBACK (PLAY & S T OP)
REMOTE
SENSOR
2
TAPE
(1 2)
OPEN/
CLOSE
c
AUDIO
IN
AUDIO
IN
Remote sensor
0.2 m - 6 m
(8" - 20')
To Next Page
Loading...
Need help?
General
